Module Failed Scp Dnld Ws-x6748-ge-tx Serial Number

%ONLINE-SP-6-TIMER: Module *module number*, Proc. 0. Failed to bring onlinebecause of timer event%C6KPWR-SP-4-DISABLED: power to module in slot *slot number* set off(Module Failed SCP dnld)%ONLINE-SP-6-REGN_TIMER: Module *module number*, Proc. 0. Failed tobring online because of registration timer event%C6KPWR-SP-4-DISABLED: power to module in slot *slot number* set off(Module Failed SCP dnld)

Module Failed Scp Dnld Ws-x6748-ge-tx Serial Number

Download: https://urlgoal.com/2vGOze

%CONST_DIAG-SP-3-HM_TEST_FAIL: Module *module number* TestSPRPInbandPingconsecutive failure count:5%CONST_DIAG-SP-4-HM_TEST_WARNING: Sup switchover will occur after 10consecutive failures%CONST_DIAG-SP-3-HM_TEST_FAIL: Module *module number* TestSPRPInbandPingconsecutive failure count:10%CONST_DIAG-SP-2-HM_SUP_SWOVER: Supervisor card switchover due to unrecoverableerrors, Reason: Failed TestSPRPInbandPin

If the status is power-bad, the switch is able to see a card, but unable to allocate power. This is possible if the Supervisor Engine is not able access the serial PROM (SPROM) contents on the module in order to determine the identification of the line card. You can issue the show idprom module command in order to verify if the SPROM is readable. If the SPROM is not accessible, you can reset the module. 2ff7e9595c